OPERATING INSTRUCTIONS

APPLICATION: ALL MODELS

By JES Innovations, Inc. Visit our website at http://www.xtremegate.com.

SLIDE-OUT TRUCK BED ASSEMBLY XGW-0002U XGN-0004U PATENTS PENDING

Deploying the X-TREME GATE Slide-Out Truck Bed Extender:

STEP 1. Open the tailgate and slide the extending panel out of the housing (to the rear like a drawer).

STEP 2. Raise the side panels to a vertical position.

STEP 3. Raise/rotate the panels up and forward until the end panels rest on the housing.

STEP 4. Slide the spring loaded sliding portion of the retainer clip to the rear and slide the retainer clip hole over the retainer/striker post and release the clip.

STEP 5. Repeat on the other side.

Fig. A	Fig. B	Fig. C

Stowing the X-TREME GATE Slide-Out Truck Bed Extender:

STEP 1. Open the retainer clip by compressing the spring loaded mechanism and remove the side panel from the retainer/striker post and release the clip

STEP 2. Repeat on the other side.

STEP 3. Lay the side panels on the end panel.

STEP 4. Slide the extending panel completely back into the housing.

STEP 5. Close the tailgate.

Fig. A	Fig. B	Fig. C

Please refer to the X-Treme Gate Website for additional support at http://www.xtremegate.com.